Shop
Showing 1–24 of 188 results
-
Electronic Components, Relays
1 Channel 5V Relay Module with Optocoupler
- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
SKU: TFF1-002 -
-
Electronic Components, Berg Strips
1×40 Pin 2.54mm Pitch Male Berg Strip – Break Away Header – Straight
Electronic Components, Berg Strips1×40 Pin 2.54mm Pitch Male Berg Strip – Break Away Header – Straight
- Number of Pins: 40.
- Pin Spacing(pitch): 2.54 mm.
- Pin height: 6 mm.
- Square Posts.
- Stackable End to End and Side to side.
- It can be manually broken for the length needed.
- Standoffs allow cleaning of solder contaminants.
SKU: TFF6-004 -
-
Berg Strips
2×40 Pin 2.54mm Pitch Female Berg Strip – Break Away Header – Straight
This 2×40 Pin Female Break Away Header has the industry standard spacing of 2.54mm and are designed for soldering directly into printed circuit boards (PCB). They are supplied Best for extension of pins of Microcontorllers and ICs.
SKU: TDF7-004 -
Electronic Components, Displays, LCD Display
3.5in TFT Touchscreen display | 480×320 TFT Touch Screen High Quality Display
Electronic Components, Displays, LCD Display3.5in TFT Touchscreen display | 480×320 TFT Touch Screen High Quality Display
- 3.5″ diagonal LCD TFT display, with bright 4 white-LED backlights, default state: on
- It can control the backlight to connect the transistor to a digital pin
- 480×320 Pixels, with colorful and 18-bit, 262,000 different kinds of shade
- 4-wire resistive touchscreen
- 8-bit digital interface, plus 4 control lines
SKU: TAF5-006 -
-
-
Relays
4 Channel Relay Module Isolated Optocoupler 5V 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
- Useful for appliance control;
- DC or AC signal, control, you can control the 220V AC load;
- There is a normally open and one normally closed contact;
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: TDF6-003 -
IoT & Wireless Boards
4G Development Board with GNSS/GPS & BLE
- Input Supply: 5V-12V DC
- DATA Transfer LTE(Mbps): 10 Downlink / 5 Uplink
- SIM Holder: Micro SIM
- SIMCOM A7672S 4G LTE chip on-board
- Builtin GNSS Support
- Builtin BLE Support
- Builtin Microphone
- Supports 4G + 2G (JIO SIM supported)
- Works with Arduino, ESP8266, ESP32
SKU: n/a -
Projects For Sale
555 Touch Piano Components (without soldering)
The kit contains
- NE555 IC x 1
- Speaker x 1
- CR2032 Battery x 2
- Battery Holder x 2
- General Purpose PCB x 1
- 1nf Capacitor x 1
- 2nf Capacitor x 1
- 10uF Capacitor x 1
- 330k Resistor x 1
- 10k Resistor x 1
- On-Off Switch x 1
- Single Core wires x 2
- Connection Diagram Image x 1
SKU: TDF6-005 -
Relays
8 Channel Relay Module Isolated Optocoupler 5V 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Channel: 8 channel
- Relay Operating Voltage: 5V
- Power supply and relay instructions, lit, disconnect is off;
- Input signal, signal, common Terminal and start conducting;
- Input signal, signal, common Terminal and start conducting;
- Useful for appliance control;
- DC or AC signal, control, you can control the 220V AC load;
- There is a normally open and one normally close contact;
- The module is compliant with international safety standards, control and load areas isolation trenches.
* Product Images are shown for illustrative purposes
SKU: TDF6-004