Shop
Showing 25–48 of 260 results
-
Motors & Motor Drivers, Robotics, Robotics Project
2WD Robot Kit | 2 Wheel Robot Kit
- Very handy and simple in assembling/disassembling.
- Strong components to withstand extreme terrain conditions.
- Transparent Car Chassis.
- Attractive design.
- Double-layer structure, many mounting holes, enough space
- Easy to install a variety of control panels, sensors
- Educational toys, Ideal for the DIY platform
SKU: TDF1-005 -
Berg Strips
2×40 Pin 2.54mm Pitch Female Berg Strip – Break Away Header – Straight
This 2×40 Pin Female Break Away Header has the industry standard spacing of 2.54mm and are designed for soldering directly into printed circuit boards (PCB). They are supplied Best for extension of pins of Microcontorllers and ICs.
SKU: TDF7-004 -
Sensors
37 IN 1 Sensors Kit for Arduino
- For beginners who are interested in Arduino
- A complete set of Arduino’s most common and useful electronic components
- Infrared sensor receiving module
- Laser sensor module
- Temperature and humidity sensor module
- Infrared sensor module
- 5v relay module
- Obstacle avoidance sensor module.
SKU: THF1-001 -
-
-
Relays
4 Channel Relay Module Isolated Optocoupler 5V 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
- Useful for appliance control;
- DC or AC signal, control, you can control the 220V AC load;
- There is a normally open and one normally closed contact;
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: TDF6-004-1 -
Motors & Motor Drivers, Projects For Sale, Robotics, Robotics Project
4 Wheel Smart Car Robot Chassis Kit
Motors & Motor Drivers, Projects For Sale, Robotics, Robotics Project4 Wheel Smart Car Robot Chassis Kit
- Very handy and simple in assembling/disassembling.
- Strong components so as to withstand extreme terrain conditions.
- Transparent Car Chassis.
- Attractive design.
- Double layer structure, much of mounting holes, enough space
- Easy to install a variety of control panels, sensors
- Educational toys, Ideal for DIY platform
SKU: THF1-002 -
Resistors, Electronic Components
470 ohm, 1/4 Watt Resistor with 1% tolerance (Pack of 10)
The 470 ohm Carbon Film Resistors are typical axial-lead resistors, which have much better temperature stability and provide lower noise, and are generally better for high frequency or radiofrequency applications.
SKU: TBF7-003-4 -
IoT & Wireless Boards, GPS Tracker Projects, Projects For Sale
4G Development Board with GNSS/GPS & BLE
IoT & Wireless Boards, GPS Tracker Projects, Projects For Sale4G Development Board with GNSS/GPS & BLE
- Input Supply: 5V-12V DC
- DATA Transfer LTE(Mbps): 10 Downlink / 5 Uplink
- SIM Holder: Micro SIM
- SIMCOM A7672S 4G LTE chip on-board
- Builtin GNSS Support
- Builtin BLE Support
- Builtin Microphone
- Supports 4G + 2G (JIO SIM supported)
- Works with Arduino, ESP8266, ESP32
SKU: TBF8-001 -
-
Projects For Sale
555 Touch Piano Components (without soldering)
The kit contains
- NE555 IC x 1
- Speaker x 1
- CR2032 Battery x 2
- Battery Holder x 2
- General Purpose PCB x 1
- 1nf Capacitor x 1
- 2nf Capacitor x 1
- 10uF Capacitor x 1
- 330k Resistor x 1
- 10k Resistor x 1
- On-Off Switch x 1
- Single Core wires x 2
- Connection Diagram Image x 1
SKU: TDF6-005 -
-
Electronic Components
5V-12V Big Buzzer
- Wired Plastic Shell Active Piezo Electronic Alarm Buzzer
- Operates in a wide range of voltage (5V to 12V)
- Long life and stable performance
- Lightweight with a simple construction
- Piezoceramic material used for the disc, providing piezoelectric effect
- Produces sound based on the reverse of the piezoelectric effect
SKU: TDF9-005