relay module
Showing all 4 results
-
Relays
4 Channel Relay Module Isolated Optocoupler 5V 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
- Useful for appliance control;
- DC or AC signal, control, you can control the 220V AC load;
- There is a normally open and one normally closed contact;
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: TDF6-004-1 -
Relays
8 Channel Relay Module Isolated Optocoupler 5V 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Channel: 8 channel
- Relay Operating Voltage: 5V
- Power supply and relay instructions, lit, disconnect is off;
- Input signal, signal, common Terminal and start conducting;
- Input signal, signal, common Terminal and start conducting;
- Useful for appliance control;
- DC or AC signal, control, you can control the 220V AC load;
- There is a normally open and one normally close contact;
- The module is compliant with international safety standards, control and load areas isolation trenches.
* Product Images are shown for illustrative purposes
SKU: TDF6-004 -
Electronic Components, Relays
1 Channel 5V Relay Module without Optocoupler
- The 8550 transistor drive, driveability.
- It has a relay status indicator led Power LED(Green).
- Relay control interface by single-chip IO.
- Low-level suction close, high-level release.
- Easy to use, simple 3-line structure.
SKU: TAF3-004 -
Relays
5V Dual Channel Relay Module with Optocoupler Good Quality
- Low-Level Trigger Relay Module
- Two separate LEDs for On/Off indication of the Relay.
- Triggering input voltage 3.3V – 5V
- Two separate LEDs for On/Off indication of the Relay
- Triggering input voltage 3.3V – 5V 4)
- Back EMF protection
- Back EMF protection 2 LEDs to indicate when relays are ON.
- Works with logic-level signals from 3.3V or 5V devices
- Opto isolation circuitry
- Module with diode current protection, short response time
- AC Control Voltage: 250V @max.10A
- DC Control Voltage: 30V @max. 10A
SKU: TAF3-001
