Search results: “sensor”
Showing 1–24 of 97 results
-
Sensors
AHT10 High Precision Digital Temperature and Humidity Sensor Module
- Interface: I2C
- Operating Voltage: 1.8 – 6.0 V
- Accuracy (Humidity): ± 2% (typical)
- Accuracy (Temperature): ± 0.3 °C (typical)
- Resolution (Humidity): 0.024%
- Resolution (Temperature): 0.01 °C
- Operating Temperature: -40°C to 85°C
- Interface Size: 4 x 2.54mm pitch
SKU: TDF6-003 -
-
Sensors
Speed Measuring Sensor Module For Arduino
- Using imported groove optical coupling sensor, width 5mm.
- It has the output state light, if output high level, the lights are off. if output low level, it on.
- If it covered, it will output high level; otherwise, its output low level.
- Good signal and waveform, with a strong driving ability for more than 15mA.
- Equipped with a fixed bolt hole, easy install.
- Use the LM393 wide voltage comparer.
SKU: TBF9-004-1 -
Sensors
DHT22 Digital Temperature and Humidity Sensor Module
- Measuring range: temperature -40-80 ℃; humidity 0; 99.9%RH
- Measurement accuracy (25℃): temperature: + 0.5; humidity: + 2%RH (10; 90%RH)
- Resolution: temperature: 0.1 ℃, humidity: 0.1%RH
- Attenuation value: temperature: <1℃ / year; humidity: < 1%RH/ years
- High precision
- Capacitive type
- Full range temperature compensated
- Relative humidity and temperature measurement
- Calibrated digital signal
- Outstanding long-term stability
SKU: TDF8-003 -
Sensors
37 IN 1 Sensors Kit for Arduino
- For beginners who are interested in Arduino
- A complete set of Arduino’s most common and useful electronic components
- Infrared sensor receiving module
- Laser sensor module
- Temperature and humidity sensor module
- Infrared sensor module
- 5v relay module
- Obstacle avoidance sensor module.
SKU: THF1-001 -
Sensors
TSOP1738 – Infrared Sensor
- Photo detector and preamplifier in one package
- Internal filter for PCM frequency
- Improved shielding against electrical field disturbance
- TTL and CMOS compatibility
- Output active low
- Low power consumption
- High immunity against ambient light
- Continuous data transmission possible (up to 2400 bps)
- Suitable burst length ≥10 cycles/burst
SKU: TFF4-004 -
Sensors
IR High Range NPN Optical Proximity Sensor | E-18 Proximity Sensor | 80cm Amazing Range
- Very Small in size
- Less influence on the color of reflected objects, reflectivity
- Industrial grade quality
- Can detect colour difference from certain range
- TTL output high whenever sensor senses a obstacle
- Detecting distance of 3cm to 80cm
- External control circuit unnecessary
- Low cost
- Has inbuilt lenses assembly and potentiometer to set range of the module
- Output indication LED
SKU: TFF7-002 -
Sensors
MPU6050 3-Axis Accelerometer and Gyro Sensor
- Chip built-in 16bit AD converter, 16-bit data output.
- I2C Digital-output of 6 or 9-axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format.
- Selectable Solder Jumpers on CLK, FSYNC, and AD0.
- Digital Motion Processingâ„¢ (DMPâ„¢) engine offloads complex MotionFusion, sensor timing synchronization, and gesture detection.
- Embedded algorithms for run-time bias and compass calibration. No user intervention is required.
- Digital-output temperature sensor.
SKU: TAF6-006-1 -
Sensors
TCS3200 Color Recognition Sensor Module
- Operating Voltage: 3V-5V
- High-resolution conversion of light intensity to frequency.
- Chip pins all has drawn for standard 100.
- Put the needle (2.54 mm).
- Mil-convenient for bitmap board.
- Programmable color and full-scale output frequency.
- Communicate directly with a microcontroller.
- Low-profile surface mount package.
SKU: TFF7-001 -
-
Sensors
MQ-7 CO Carbon Monoxide Coal Gas Sensor Module
- The analog output voltage, the higher the concentration the higher the voltage.
- The carbon monoxide detection with better sensitivity.
- There are four screw holes for easy positioning.
- With a long service life and reliable stability.
- Rapid response and recovery characteristics.
SKU: TFF3-003 -
Electronic Components, Sensors
Vibration Sensor Module SW-420
- Using SW-420 normally closed type vibration sensor
- Comparator output, clean signal, good waveform, strong driving ability, >15mA
- Operating voltage 3.3V ~ 5V
- Output format: digital switching output (0 and 1)
- Using a wide voltage LM393 comparator
- With bolt holes for easy installation
SKU: TFF2-003 -
-
-
-
Sensors
Flame Sensor infrared Receiver Ignition source detection module
- Output Channel: 1
- Power Supply: 3.3/5V
- Built in a potentiometer for sensitivity control.
- Onboard signal output indication, output effective signal is high, at the same time the indicator light up, the output signal can directly connect to microcontroller IO.
- Detection angle about 60 degrees, the flame spectrum especially sensitive.
- The flame of the most sensitive sensors flame, the regular light is also a response, generally used for fire alarm purposes.
SKU: TFF2-001 -
Sensors
MQ3 Alcohol Sensor Module
- Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
- Current Consumption: 150mA.
- DO output:Â 0.1 and 5V.
- AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detecting Concentration: 0.05-10mg/L Alcohol.
SKU: TFF3-001 -
Electronic Components, Sensors
ACS712 20A Current Sensor Module Good Quality
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 20A
- Sensitivity: 100mV/A
SKU: TBF2-003 -
Sensors, Electronic Components
MQ 135 Air Quality/Gas Detector Sensor Module For Arduino
- Sensitivity to Ammonia, Sulphide, and Benzene steam
- Sensitive for benzene, alcohol, smoke
- Fast response and recovery
- Adjustable sensitivity
- Signal output indicator
- Output voltage boosts along with the concentration of the measured gases increases.
SKU: TBF3-006
